Instead of displaying “All Bands” you can choose to display individual band numbers, which are notated in the image above. Whenever the sensor captures images manually (using either the physical button or the web button), the selected image(s) will be displayed in the Live View page based on the setting of the “Band” pull-down menu. ![]() Provides a live preview of images captured with the sensor. We recommend re-calibrating the compass regularly, but at the very least when it has been moved to another location on the aircraft, or if you are flying in a different time zone (which would slightly alter the magnetic heading).Ĭapture Config: This shows your current setting for your Automatic Triggering Mode. If properly calibrated, you can check the reading against a handheld compass to verify its accuracy. These unit of measurement cannot be converted at this time. Speed: Current speed detected in meters per second. Powering the camera off and then back on will reset the ground estimate. If the initial GPS lock is not very accurate, it's possible for the AGL reported to be significantly off, especially as a better GPS lock is established over time. The altitude AGL reported on the status page is an estimate based on the initial GPS lock received by the camera. Location: This is the detected location coming from GPS, written in Decimal Degrees.Īltitude: This indicates your current altitude in Mean Seal Level (MSL) and Above Ground Level (AGL). It cannot be changed to a different time zone, as many data processing programs rely on UTC for accurate calculations. Once GPS has a lock, this will update to the current date/time in UTC (Universal Time). Time: Will initially be set at UNIX time ( 00:00:00 UTC). There is also an area at the bottom of the page that shows the signal strength of detected satellites.ĭLS Status: Will be green if DLS is powered and communicating with the camera. GPS Sats: Indicates the amount of satellites that are detected and currently being used. ![]() Storage: This will report your available and maximum storage space, as well as the file system (e.g. “Capture Config” shows the current automatic trigger setting (overlap, timer, external trigger, or disabled). If and when the sensor detects a GPS it will update the time automatically. If no GPS is found, the time will show as UNIX time (January 1, 1970). The time is provided by a connected GPS device. Provides status information for the sensor and the GPS receiver that is connected to it. The IP address can be changed in Settings > Advanced > Ethernet Configuration. Once the host computer's Ethernet has been configured, connect to the configuration page using the Ethernet IP address (192.168.1.83 by default). Set the host computer’s subnet mask to 255.255.255.0. We recommend the IP address 192.168.1.40 if it is not in use already. Set the host computer’s Ethernet to use a manual IP address in the block 192.168.1.0-255. First, you will need a cable or adapter that connects an Ethernet cable to the appropriate port on the sensor (see your sensor’s integration guide for details). It is possible to connect to the sensor via Ethernet. Once connected to the sensor’s Wi-Fi, open any web browser and access the sensor’s web page by typing in “192.168.10.254” in the address bar of the browser (no quotes). The password for this Wi-Fi access point is micasense The serial number is printed on the rear of the sensor. The SSID includes the sensor name and serial number. When the sensor has been powered on and has finished initializing, it will broadcast a Wi-Fi signal (if the Wi-Fi adapter is attached). The firmware version number is shown at the bottom of the page.Īny device (such as a computer, tablet, or smartphone) can be used to establish a connection with the sensor using Wi-Fi or Ethernet. The current firmware version can be verified the “Settings” page on the sensor’s web page as shown below.Follow the Firmware Update Instructions.Download the firmware from the MicaSense Camera Firmware Download Page.The firmware in the sensor can be easily updated as follows: It is essential to keep the sensor firmware updated at all times. ![]() Configure the sensor’s IP address (optional) 23
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |